Construction

Cross beam-mounted load weighing device, with 6.5 ft • 2 meter cord and all necessary mounting hardware, 0-20, 4-20 or 0-24 mA analog output This load weighing sensor mounts on the cross beams. An LM3D-EMC-CSA control unit is required (see page 65). Test weights are also required for calibration. USE ONE SENSOR when the cab capacity is 2200 lbs • 1000 kg or less, AND when the cross beams are fixed to the same vertical beam, AND when the cab is situated symmetrically within the car sling. USE TWO

SKU: 023-4-0001

Backorder

Cross beam-mounted load weighing device, with 6.5 ft • 2 meter cord and all necessary mounting hardware, 0-20, 4-20 or 0-24 mA analog output This load weighing sensor mounts on the cross beams. An LM3D-EMC-CSA control unit is required (see page 65). Test weights are also required for calibration. USE ONE SENSOR when the cab capacity is 2200 lbs • 1000 kg or less, AND when the cross beams are fixed to the same vertical beam, AND when the cab is situated symmetrically within the car sling. USE TWO SENSORS when the cab capacity exceeds 2200 lbs • 1000 kg, OR when the depth of the cab is 1.4x the cab’s width, OR when the cab is NOT situated symmetrically within the car sling. Cab displays Part Description Number LW-CABDISPLA-ML Cab display, overload shown by flashing and intermittent buzzing LW-CABDISPLA-LPM Cab display, load shown by progressively lit LEDs, overload by flashing and intermittent buzzing This display cannot be used with LW-ILC3-M-ANLOG 1$